Delay Mode
(Master Remote Only)

1. Set the Delay switch on the Master Remote Control to MAX.

2. Press [ARM] on the Remote Control.  Lamps connected to modules turn on.  The Console chimes for approximately 1 minute while you leave the house.  You then hear a beep signifying that the system is armed, and the lamp(s) turn off.

Open a door (that has its sensor set to MAX).  The Console gives a pre-alarm beep, and lamps connected to modules turn on.  After a delay of approximately 30 seconds the alarm sounds, lamps connected to the Lamp and Wall Switch Modules flash, and the automatic dialer dials out.

3. Press [DISARM] to stop the siren.
The lights remain on.

Delayed arm/alarm only affects sensors set to MAX.  If you open a window (with its sensor set to MIN) the alarm trips instantly even if the system is armed for delayed alarm.

Arm Home/Arm Away
(Master Remote Only)

The Master Remote Control lets you arm the system with or without Motion Detectors armed.

If you press [ARM AWAY] on the Master Remote Control, all Door/Window Sensors AND Motion detectors will be armed.

If you press [ARM HOME] on the Master Remote Control, ONLY Door/Window Sensors will be armed.  The Motion Detectors will not be armed.  This lets you arm the system at night without accidentally tripping the system yourself when you move around the house.

< prev | Home |  next >