FL Wireless CCTV Cameras CCTV Surveillance Cameras CCTV Security Camera FL Residential Security Cameras Fake Security Cameras Outdoor Camera

 

  

Wireless home security alarm system (Voice Dialing)
Back to all Wireless Alarm Systems

Setting Up the Powerhorn

The POWERHORN Remote Powerline siren responds to signals transmitted by the Console (over house wiring).

When the alarm trips, the Console's siren sounds and lights flash.  After the lights have flashed on and off about 5 times, the POWERHORN trips.  It sounds for as long as the system is in alarm and then shuts off about 10 seconds after the alarm resets or is disarmed.

1. Plug POWERHORN into a standard AC outlet (not one controlled by a wall switch).

Using the POWERHORN with other Controllers

In a panic situation, you can trip the POWERHORN from other types of Controllers by wither of the following methods:

1. Press All Lights On followed by All Units Off repetitively.

2. Press the Panic Button (sold separately).

Storing a Voice Message

1. Plug the included earphone into the jack on the side of the Console.

2. Set the Console to INSTALL.

3. Press the [RECORD] button.
The RECORD light turns on.

4. Speak clearly into the microphone on the front of the Console.  You can record up to 15 seconds of speech.  For example: "This is Mrs. Smith.  There's a strange noise in my house.  Please press 0 to listen."
After 15 seconds the RECORD light turns off.

5. Set the Console to RUN.  The Console plays back your message through the earphone so you can hear what it sounds like.

6. If you want to hear the message again, set the Console to INSTALL then back to RUN.

 

 

 

 

 

 

 

 

 

 

 

Setting Up the Telephone Dialer

Only program the Console to call someone with whom you have discussed your Security System and who would expect such a call (such as a friend, relative or neighbor) who can then listen to determine if there is a real problem.  The person can then call for assistance to be sent if necessary, or call you back to see if everything is ok.  DO NOT program the Console to call anyone who would not expect the call (the Police for example).

1. Set the Console's INSTALL/RUN switch to INSTALL.
2. Press [PROG] button.
3. Enter the first phone number that you want the Console to call in the event of a problem. e.g 555-1234
4. Press the [MEM] button.
5. Press [1] to store the phone number in memory location 1.

Press [PROG], enter a second number, then press [MEM], [2].

Press [PROG], enter a third number, then press [MEM], [3].

Press [PROG], enter a fourth number, then press [MEM], [4].

Repeat steps 1 through 5 to change a phone number.

If you only want to store 1 phone number, "fill up" the memory locations with the same number. i.e.

Memory Location 1 - 555-1234
Memory Location 2 - 555-1234
Memory Location 3 - 555-1234
Memory Location 4 - 555-1234

For 2 phone numbers:

Memory Location 1 - 555-1234
Memory Location 2 - 555-1234
Memory Location 3 - 555-6789
Memory Location 4 - 555-6789

The Console will not work through a switchboard or phone system that requires a delay after the "9" for an outside line.