Setting Up the Console

1. Plug the Console into an AC outlet which is not controlled by a wall switch.

2. Fully extend the RF antenna.

3. Plug the included phone cord into the socket on back of Console and plug the other end into an unused telephone jack.  If you don't have an unused jack use the included "T" adapter to plug the Console and your telephone into the same jack.

4. Install a 9-volt alkaline battery in the Console's battery compartment.

5. Set the Console's INSTALL/RUN switch to INSTALL.

6. The switch on the bottom of the Console is set for tone, if you don't have touch-tone service, set it to pulse.

Locating the Console

Locate the Console near a phone jack and where it can easily be seen on a day to day basis so that it will be noticed if any of the zone indicators report a problem.  Later, when you are familiar with the operation of the system you should test all the Sensors, Motion Detectors, and Remote Controls from the locations you intend to use them.